Hi!

I upgraded my kernel to 2.6.12.1. I compiled it using the same config of the old kernel (2.6.9).

First, I noticed the kernel stops for about 20 seconds in the boot process, when the following line appears in the screen:

...
ide1 at 0x170-0x177,0x376 on irq 15

The same line appeared when using 2.6.9, but there was no stopping at this point.

After boot, I tried to burn a cd using cdrecord (I have SCSI emulation enabled), but the disk is burnt incorrectly, because cdrecord spends more than five minutes saying "Writing pregap for track 1 at -150", and then starts burning the disk at 999X speed.

I hope somebody can give me a solution to this (without disabling SCSI emulation). Thank you very much.

--

Paul