Hi, guys,
I have a console line, which is serial console (RS232) on USB. It works well

with minicom in my ubuntu 8.04  when I connect it to my netscreen-5xt.

But, it can't work with my OpenBSD 4.2.

 Due to my command line "usbdevs -dv" output, I configure it as these below

"Serial Device : /dev/usb1" , Bits setting is "9600 8N1", turn off "hardware

Flow Contol ". Unlikely, it can't work.
-------------------------------------

My /var/log/messages output is :
Apr 20 23:48:00 uestc /bsd: ugen0 at uhub1 port 2

Apr 20 23:48:00 uestc /bsd:

Apr 20 23:48:00 uestc /bsd: ugen0: vendor 0x1a86 USB2.0-Ser!, rev 1.10/2.54,

addr 2
------------------------------------------
My usbdevs output is :

Controller /dev/usb0:

addr 1: high speed, self powered, config 1, EHCI root hub(0x0000),

Intel(0x8086), rev 1.00

  uhub0

 port 1 powered

 port 2 powered

 port 3 powered

 port 4 powered

 port 5 powered

 port 6 powered

 port 7 powered

 port 8 powered

Controller /dev/usb1:

addr 1: full speed, self powered, config 1, UHCI root hub(0x0000),

Intel(0x8086), rev 1.00

  uhub1

 port 1 powered

 port 2 addr 2: full speed, power 96 mA, config 1, USB2.0-Ser!(0x7523),

vendor 0x1a86(0x1a86), rev 2.54

   ugen0

Controller /dev/usb2:

addr 1: full speed, self powered, config 1, UHCI root hub(0x0000),

Intel(0x8086), rev 1.00

  uhub2

 port 1 powered

 port 2 powered

Controller /dev/usb3:

addr 1: full speed, self powered, config 1, UHCI root hub(0x0000),

Intel(0x8086), rev 1.00

  uhub3

 port 1 powered

 port 2 powered

Controller /dev/usb4:

addr 1: full speed, self powered, config 1, UHCI root hub(0x0000),

Intel(0x8086), rev 1.00

  uhub4

 port 1 powered

 port 2 powered