> Hey,
>
> I tried following that article but I got stuck at the part where you
> start partition your second drive. I created the first partition with
> 100mb and type of 4.2 BSD then when I tried to create the second
> partition on my drive as FS_RAID as the article says but it said that
> FS_RAID is an unknown type and treated my partition as unknown?
>
> To me that part of the article on how to partition my disk is totally
> unclear. All it says is make the first partition 100m for the boot
> which makes sense then it doesn't say how to partition the rest of
> your drive to setup for the RAID 1? Can someone clarify this a bit
> more please? I'm stuck.
>
> Thanks,
> - Jake
>
> Anyways how do I fix this FS_RAID problem
>
> On 9/12/07, nicodache wrote:
> > I personnaly used the following doc to set up my software raid 1 frame :
> >
http://www.linux.com/articles/52713
> >
> > good luck :)
> >
> > On 9/12/07, Steve Williams wrote:
> > > Jake Conk wrote:
> > > > Hello,
> > > >
> > > > I've searched hi and low for hours on how to setup my system of a RAID
> > > > 1 and basically what it comes down to is ccd and/or Raid Frame. I've
> > > > found helpful docs on using some of the commands and where to put my
> > > > configurations but nothing seems complete enough for me to figure it
> > > > out.
> > > >
> > > > I have OpenBSD 4.1 installed on one disk and I have an exact duplicate
> > > > disk where i want to mirror my installation to incase of disk failure.
> > > > If this needs to be setup during install I'm willing reinstall
> > > > everything or if there is a way to configure my disks for ccd and
> > > > mirror them to the second disk then I'm willing to do that also.
> > > >
> > > > Basically I don't know how to get this ball rolling, I've read 1) I
> > > > must change the disk type with disk label to ccd. Then 2) create ccd0
> > > > with ccdconfig and tell it to mirror disk 1 to disk 2. It then 3)
> > > > finally says to put my configuration into ccd.conf so that it can be
> > > > read in on boot by my system and of course put the stuff in fstab to
> > > > have it mounted on boot but thats all I know, everything is very vague
> > > > and no exact details on how to do this step by step with a new install
> > > > or a already running system.
> > > >
> > > > Can someone please help provide a step by step way to mirror my whole
> > > > disk to a second disk by ressetting back up OpenBSD from scratch or if
> > > > possible configure my already installed system? I don't care if its
> > > > with ccd or another tool as long as I have a disk failover solution.
> > > >
> > > >
> > > > Please Please Please and Thanks!
> > > > - Jake
> > > >
> > > Hi,
> > >
> > > Not for CCD, but raidframe..
> > >
> > > Search the mailing list archives for a thread with a subject "Seeking
> > > info for RAID 1 on OpenBSD". In there you will find all sorts of info.
> > >
> > >
http://marc.info/?l=openbsd-misc&m=116360194522004&w=2
> > >
> > >
http://www.packetmischief.ca/openbsd/doc/raidadmin/
> > >
> > > Good Luck,
> > >
> > > Thanks,
> > > Steve Williams
