Hey,
I tried following that article but I got stuck at the part where you

start partition your second drive. I created the first partition with

100mb and type of 4.2 BSD then when I tried to create the second

partition on my drive as FS_RAID as the article says but it said that

FS_RAID is an unknown type and treated my partition as unknown?
To me that part of the article on how to partition my disk is totally

unclear. All it says is make the first partition 100m for the boot

which makes sense then it doesn't say how to partition the rest of

your drive to setup for the RAID 1? Can someone clarify this a bit

more please? I'm stuck.
Thanks,

- Jake
Anyways how do I fix this FS_RAID problem
On 9/12/07, nicodache  wrote:

quoted text
> I personnaly used the following doc to set up my software raid 1 frame :

> http://www.linux.com/articles/52713

>

> good luck :)

>

> On 9/12/07, Steve Williams  wrote:

> > Jake Conk wrote:

> > > Hello,

> > >

> > > I've searched hi and low for hours on how to setup my system of a RAID

> > > 1 and basically what it comes down to is ccd and/or Raid Frame. I've

> > > found helpful docs on using some of the commands and where to put my

> > > configurations but nothing seems complete enough for me to figure it

> > > out.

> > >

> > > I have OpenBSD 4.1 installed on one disk and I have an exact duplicate

> > > disk where i want to mirror my installation to incase of disk failure.

> > > If this needs to be setup during install I'm willing reinstall

> > > everything or if there is a way to configure my disks for ccd and

> > > mirror them to the second disk then I'm willing to do that also.

> > >

> > > Basically I don't know how to get this ball rolling, I've read 1) I

> > > must change the disk type with disk label to ccd. Then 2) create ccd0

> > > with ccdconfig and tell it to mirror disk 1 to disk 2. It then 3)

> > > finally says to put my configuration into ccd.conf so that it can be

> > > read in on boot by my system and of course put the stuff in fstab to

> > > have it mounted on boot but thats all I know, everything is very vague

> > > and no exact details on how to do this step by step with a new install

> > > or a already running system.

> > >

> > > Can someone please help provide a step by step way to mirror my whole

> > > disk to a second disk by ressetting back up OpenBSD from scratch or if

> > > possible configure my already installed system? I don't care if its

> > > with ccd or another tool as long as I have a disk failover solution.

> > >

> > >

> > > Please Please Please and Thanks!

> > > - Jake

> > >

> > Hi,

> >

> > Not for CCD, but raidframe..

> >

> > Search the mailing list archives for a thread with a subject "Seeking

> > info for RAID 1 on OpenBSD".  In there you will find all sorts of info.

> >

> > http://marc.info/?l=openbsd-misc&m=116360194522004&w=2

> >

> > http://www.packetmischief.ca/openbsd/doc/raidadmin/

> >

> > Good Luck,

> >

> > Thanks,

> > Steve Williams