> Jake Conk wrote:
> > Hello,
> >
> > I've searched hi and low for hours on how to setup my system of a RAID
> > 1 and basically what it comes down to is ccd and/or Raid Frame. I've
> > found helpful docs on using some of the commands and where to put my
> > configurations but nothing seems complete enough for me to figure it
> > out.
> >
> > I have OpenBSD 4.1 installed on one disk and I have an exact duplicate
> > disk where i want to mirror my installation to incase of disk failure.
> > If this needs to be setup during install I'm willing reinstall
> > everything or if there is a way to configure my disks for ccd and
> > mirror them to the second disk then I'm willing to do that also.
> >
> > Basically I don't know how to get this ball rolling, I've read 1) I
> > must change the disk type with disk label to ccd. Then 2) create ccd0
> > with ccdconfig and tell it to mirror disk 1 to disk 2. It then 3)
> > finally says to put my configuration into ccd.conf so that it can be
> > read in on boot by my system and of course put the stuff in fstab to
> > have it mounted on boot but thats all I know, everything is very vague
> > and no exact details on how to do this step by step with a new install
> > or a already running system.
> >
> > Can someone please help provide a step by step way to mirror my whole
> > disk to a second disk by ressetting back up OpenBSD from scratch or if
> > possible configure my already installed system? I don't care if its
> > with ccd or another tool as long as I have a disk failover solution.
> >
> >
> > Please Please Please and Thanks!
> > - Jake
> >
> Hi,
>
> Not for CCD, but raidframe..
>
> Search the mailing list archives for a thread with a subject "Seeking
> info for RAID 1 on OpenBSD". In there you will find all sorts of info.
>
>
http://marc.info/?l=openbsd-misc&m=116360194522004&w=2
>
>
http://www.packetmischief.ca/openbsd/doc/raidadmin/
>
> Good Luck,
>
> Thanks,
> Steve Williams
