Rafael J. Wysocki schrieb:
quoted text
> Hi,
> 
> The following two patches add basic PCI runtime power management to the r8169
> and e1000e drivers.
> 
> It works so that the adapter is put into PCI D3 if there's no network cable
> attached to it and back into PCI D0 once the cable has been detected.
> 
> The feature is disabled by default and it can be enabled by writing "auto" to
> the device's /sys/devices/.../power/control file.  Writing "on" to this file
> disables the feature again.
> 
> The patches have been tested on MSI Wind U100 (r8169) and Toshiba Portege
> R500 (e1000e).
> 
> Thanks,
> Rafael
> 

Hi Rafael,

Which kernel do i need for this feature? I have a mini-itx board 
combined with a daughterboard with additionally 3xRJ45, so that i have 4 
network devices:
...
01:00.0 Ethernet controller: Realtek Semiconductor Co., Ltd. 
RTL8111/8168B PCI Express Gigabit Ethernet controller (rev 03)
04:04.0 Ethernet controller: Realtek Semiconductor Co., Ltd. 
RTL-8110SC/8169SC Gigabit Ethernet (rev 10)
04:06.0 Ethernet controller: Realtek Semiconductor Co., Ltd. 
RTL-8110SC/8169SC Gigabit Ethernet (rev 10)
04:07.0 Ethernet controller: Realtek Semiconductor Co., Ltd. 
RTL-8110SC/8169SC Gigabit Ethernet (rev 10)

Not all of them are used at the same time. So how can i put the unused 
in a low power state?

regards Markus

--
To unsubscribe from this list: send the line "unsubscribe netdev" in
the body of a message to majordomo@vger.kernel.org
More majordomo info at  http://vger.kernel.org/majordomo-info.html