Hi
I have an Intel Atom D945GCLF based system. It has a realtek RTL8101E
PCI network interface.
With linux-2.6.27-rc4 - everything seems fine. I think we've been
working OK since 2.6.26ish.
With linux-2.6.27-rc5, "ifconfig eth0" just hangs. lspci -vvx reports,
after loading the driver,
PCI Express Fast Ethernet controller (rev ff) (prog-if ff)
00: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff
10: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff
20: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff
30: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff =20
Before I load the driver lspci -vvx looks OK.
I do not have (much) time to look into this any further but hopefully
this might help someone.
I know there are problems with this device on the atom board
particularly around warm start but thus far I seem to have avoided this
issue.
A cold start in this case does not help.
Lspci.bad comes from -rc5 with the r8169 driver loaded.
Lspci.good comes from -rc4 with the r8169 driver loaded
Cheers
John
Previous message: [thread] [date] [author] Next message: [thread] [date] [author]
Messages in current thread:
D945GCLF intel atom board & r8169 ethernet broken in linu ..., John Gumb, (Wed Sep 24, 4:26 am)