Hi Rusty,
Here's a few virtio_net fixes related to partial csums
and GSO. These come about from playing with the tun/tap based
GSO patches you and Herbert posted earlier.
3/3 is the signifcant one - I didn't actually reproduce
the problem with virtio_net, but rather observed it with the
tun/tap patch. In that case, packets which were sent by the
guest with a partial csum were ending up with an incorrect
csum when they were forwarded to a physical network.
Cheers,
Mark.
--
Signed-off-by: Mark McLoughlin <markmc@redhat.com> --- include/linux/virtio_net.h | 2 +- 1 files changed, 1 insertions(+), 1 deletions(-) diff --git a/include/linux/virtio_net.h b/include/linux/virtio_net.h index 9405aa6..38c0571 100644 --- a/include/linux/virtio_net.h +++ b/include/linux/virtio_net.h @@ -38,7 +38,7 @@ struct virtio_net_hdr #define VIRTIO_NET_HDR_GSO_ECN 0x80 // TCP has ECN set __u8 gso_type; __u16 hdr_len; /* Ethernet + IP + tcp/udp hdrs */ - __u16 gso_size; /* Bytes to append to gso_hdr_len per frame */ + __u16 gso_size; /* Bytes to append to hdr_len per frame */ __u16 csum_start; /* Position to start checksumming from */ __u16 csum_offset; /* Offset after that to place checksum */ }; -- 1.5.4.1 --
Signed-off-by: Mark McLoughlin <markmc@redhat.com>
---
drivers/net/virtio_net.c | 2 +-
1 files changed, 1 insertions(+), 1 deletions(-)
diff --git a/drivers/net/virtio_net.c b/drivers/net/virtio_net.c
index fe7cdf2..50e6e59 100644
--- a/drivers/net/virtio_net.c
+++ b/drivers/net/virtio_net.c
@@ -94,7 +94,7 @@ static void receive_skb(struct net_device *dev, struct sk_buff *skb,
if (hdr->flags & VIRTIO_NET_HDR_F_NEEDS_CSUM) {
pr_debug("Needs csum!\n");
- if (!skb_partial_csum_set(skb,hdr->csum_start,hdr->csum_offset))
+ if (!skb_partial_csum_set(skb, hdr->csum_start, hdr->csum_offset))
goto frame_err;
}
--
1.5.4.1
--
hdr->csum_start is the offset from the start of the ethernet
header to the transport layer checksum field. skb->csum_start
is the offset from skb->head.
skb_partial_csum_set() assumes that skb->data points to the
ethernet header - i.e. it computes skb->csum_start by adding
the headroom to hdr->csum_start.
Since eth_type_trans() skb_pull()s the ethernet header,
skb_partial_csum_set() should be called before
eth_type_trans().
Signed-off-by: Mark McLoughlin <markmc@redhat.com>
Cc: Herbert Xu <herbert@gondor.apana.org.au>
---
drivers/net/virtio_net.c | 8 +++++---
1 files changed, 5 insertions(+), 3 deletions(-)
diff --git a/drivers/net/virtio_net.c b/drivers/net/virtio_net.c
index 50e6e59..503486f 100644
--- a/drivers/net/virtio_net.c
+++ b/drivers/net/virtio_net.c
@@ -86,9 +86,7 @@ static void receive_skb(struct net_device *dev, struct sk_buff *skb,
BUG_ON(len > MAX_PACKET_LEN);
skb_trim(skb, len);
- skb->protocol = eth_type_trans(skb, dev);
- pr_debug("Receiving skb proto 0x%04x len %i type %i\n",
- ntohs(skb->protocol), skb->len, skb->pkt_type);
+
dev->stats.rx_bytes += skb->len;
dev->stats.rx_packets++;
@@ -98,6 +96,10 @@ static void receive_skb(struct net_device *dev, struct sk_buff *skb,
goto frame_err;
}
+ skb->protocol = eth_type_trans(skb, dev);
+ pr_debug("Receiving skb proto 0x%04x len %i type %i\n",
+ ntohs(skb->protocol), skb->len, skb->pkt_type);
+
if (hdr->gso_type != VIRTIO_NET_HDR_GSO_NONE) {
pr_debug("GSO!\n");
switch (hdr->gso_type & ~VIRTIO_NET_HDR_GSO_ECN) {
--
1.5.4.1
--
Good catch! Clearly shows I never ran this across a real Ethernet device :) Acked-by: Herbert Xu <herbert@gondor.apana.org.au> Thanks, -- Visit Openswan at http://www.openswan.org/ Email: Herbert Xu ~{PmV>HI~} <herbert@gondor.apana.org.au> Home Page: http://gondor.apana.org.au/~herbert/ PGP Key: http://gondor.apana.org.au/~herbert/pubkey.txt --
As should the rx_bytes += skb->len. Thanks for this! Applied (and 1/3, the typo patch). I'll backport this to -stable, as well. Thanks, Rusty. --
I compressed the whitespace to avoid going over 80 cols. A choice of lesser evils :) Cheers, Rusty. --
