To be precise, I say :
- downloaded 2.6.34rc5
- apply the jens patch
- the logfs code is the code in the 2.6.34rc5 (I have no applied other
jorn patch)
Paolo
On Tue, Apr 27, 2010 at 11:16 AM, Jens Axboe <jens.axboe@oracle.com> wrote:
quoted text > On Tue, Apr 27 2010, Paolo Minazzi wrote:
>> I have tried this patch.
>> I have enabled LOGFS, but not mounted partition with it.
>> /dev/mtdblock1 is my romfs root partition and it is OK.
>>
>> The problem is that init cannot mount my /dev/mtdblock1 romfs root.
>>
>> This is the fault :
>> Platform: Cirrus Logic EDB9315A Board (ARM920T) Rev A
>> Copyright (C) 2000, 2001, 2002, Red Hat, Inc.
>> |----------------------------------------------
>> Raw file loaded 0x00080000-0x001dce6b, assumed entry at
>> 0x00080000-----------------------------------------------------------
>> RedBoot> exec -s 0x00b00000 -r 0x00a00000 -c "root=/dev/mtdblock1
>> console=ttyAM console=tty1"--------------------------------
>> ENTRY=0xc0008000-------------------------------------------------------------------------------------------------------------
>> LENGTH=0x00300000------------------------------------------------------------------------------------------------------------
>> BASE_ADDR=0x00080000---------------------------------------------------------------------------------------------------------
>> Using base address 0x00080000 and length
>> 0x00300000--------------------------------------------------------------------------
>> Uncompressing Linux... done, booting the kernel.
>> Linux version 2.6.34-rc5 (root@darkstar) (gcc version 3.4.3) #18 Tue
>> Apr 27 10:55:55 CEST 2010
>> CPU: ARM920T [41129200] revision 0 (ARMv4T), cr=c0007177
>> CPU: VIVT data cache, VIVT instruction cache
>> Machine: Cirrus Logic EDB9315A Evaluation Board
>> Memory policy: ECC disabled, Data cache writeback
>> Built 1 zonelists in Zone order, mobility grouping on. Total pages: 32512
>> Kernel command line: root=/dev/mtdblock1 console=ttyAM console=tty1
>> PID hash table entries: 512 (order: -1, 2048 bytes)
>> Dentry cache hash table entries: 16384 (order: 4, 65536 bytes)
>> Inode-cache hash table entries: 8192 (order: 3, 32768 bytes)
>> Memory: 128MB = 128MB total
>> Memory: 126928k/126928k available, 4144k reserved, 0K highmem
>> Virtual kernel memory layout:
>> vector : 0xffff0000 - 0xffff1000 ( 4 kB)
>> fixmap : 0xfff00000 - 0xfffe0000 ( 896 kB)
>> DMA : 0xffc00000 - 0xffe00000 ( 2 MB)
>> vmalloc : 0xc8800000 - 0xfe800000 ( 864 MB)
>> lowmem : 0xc0000000 - 0xc8000000 ( 128 MB)
>> modules : 0xbf000000 - 0xc0000000 ( 16 MB)
>> .init : 0xc0008000 - 0xc0036000 ( 184 kB)
>> .text : 0xc0036000 - 0xc02ab000 (2516 kB)
>> .data : 0xc02ac000 - 0xc02c4e00 ( 100 kB)
>> SLUB: Genslabs=11, HWalign=32, Order=0-3, MinObjects=0, CPUs=1, Nodes=1
>> Hierarchical RCU implementation.
>> NR_IRQS:120
>> VIC @fefb0000: id 0x00041190, vendor 0x41
>> VIC @fefc0000: id 0x00041190, vendor 0x41
>> Console: colour dummy device 80x30
>> console [tty1] enabled
>> Calibrating delay loop... 99.73 BogoMIPS (lpj=498688)
>> Mount-cache hash table entries: 512
>> CPU: Testing write buffer coherency: ok
>> NET: Registered protocol family 16
>> ep93xx clock: PLL1 running at 200 MHz, PLL2 at 48 MHz
>> ep93xx clock: FCLK 200 MHz, HCLK 100 MHz, PCLK 50 MHz
>> ep93xx dma_m2p: M2P DMA subsystem initialized
>> bio: create slab <bio-0> at 0
>> SCSI subsystem initialized
>> usbcore: registered new interface driver usbfs
>> usbcore: registered new interface driver hub
>> usbcore: registered new device driver usb
>> NET: Registered protocol family 2
>> IP route cache hash table entries: 1024 (order: 0, 4096 bytes)
>> TCP established hash table entries: 4096 (order: 3, 32768 bytes)
>> TCP bind hash table entries: 4096 (order: 2, 16384 bytes)
>> TCP: Hash tables configured (established 4096 bind 4096)
>> TCP reno registered
>> UDP hash table entries: 256 (order: 0, 4096 bytes)
>> UDP-Lite hash table entries: 256 (order: 0, 4096 bytes)
>> NET: Registered protocol family 1
>> JFFS2 version 2.2. (NAND) © 2001-2006 Red Hat, Inc.
>> ***REGISTER LOGFS
>> ***REGISTER LOGFS DONE ret=0
>> ROMFS MTD (C) 2007 Red Hat, Inc.
>> msgmni has been set to 247
>> io scheduler noop registered
>> io scheduler deadline registered
>> io scheduler cfq registered (default)
>> Console: switching to colour frame buffer device 100x37
>> graphics fb0: registered. Mode = 800x600-16
>> Serial: AMBA driver
>> apb:uart1: ttyAM0 at MMIO 0x808c0000 (irq = 52) is a AMBA
>> console [ttyAM0] enabled
>> apb:uart2: ttyAM1 at MMIO 0x808d0000 (irq = 54) is a AMBA
>> apb:uart3: ttyAM2 at MMIO 0x808e0000 (irq = 55) is a AMBA
>> dev->num_resources=1
>> physmap platform flash device: 02000000 at 60000000
>> physmap-flash.0: Found 1 x16 devices at 0x0 in 16-bit bank
>> physmap-flash.0: Found 1 x16 devices at 0x1000000 in 16-bit bank
>> Intel/Sharp Extended Query Table at 0x0031
>> Intel/Sharp Extended Query Table at 0x0031
>> Using buffer write method
>> cfi_cmdset_0001: Erase suspend on write enabled
>> cmdlinepart partition parsing not available
>> Searching for RedBoot partition table in physmap-flash.0 at offset 0x1fe0000
>> 6 RedBoot partitions found on MTD device physmap-flash.0
>> Creating 6 MTD partitions on "physmap-flash.0":
>> 0x000000000000-0x000000040000 : "RedBoot"
>> 0x000000040000-0x000000b40000 : "ramdisk"
>> 0x000000b40000-0x000000e40000 : "zImage"
>> 0x000000e40000-0x000001fc0000 : "jffs2"
>> 0x000001fc0000-0x000001fe0000 : "RedBoot config"
>> 0x000001fe0000-0x000002000000 : "FIS directory"
>> PPP generic driver version 2.4.2
>> PPP Deflate Compression module registered
>> PPP BSD Compression module registered
>> ep93xx-eth version 0.1 loading
>> eth0: ep93xx on-chip ethernet, IRQ 39, 00:00:11:22:33:36
>> ohci_hcd: USB 1.1 'Open' Host Controller (OHCI) Driver
>> ep93xx-ohci ep93xx-ohci: EP93xx OHCI
>> ep93xx-ohci ep93xx-ohci: new USB bus registered, assigned bus number 1
>> ep93xx-ohci ep93xx-ohci: irq 56, io mem 0x80020000
>> hub 1-0:1.0: USB hub found
>> hub 1-0:1.0: 3 ports detected
>> usbcore: registered new interface driver cdc_acm
>> cdc_acm: v0.26:USB Abstract Control Model driver for USB modems and
>> ISDN adapters
>> Initializing USB Mass Storage driver...
>> usbcore: registered new interface driver usb-storage
>> USB Mass Storage support registered.
>> ep93xx-rtc ep93xx-rtc: rtc core: registered ep93xx-rtc as rtc0
>> usbcore: registered new interface driver usbhid
>> usbhid: USB HID core driver
>> TCP cubic registered
>> NET: Registered protocol family 17
>> Last power-down at UTC 08:47:16 on 27/04/2010
>> ep93xx-rtc ep93xx-rtc: setting system clock to 2010-04-27 08:47:16 UTC
>> (1272358036)
>> VFS: Cannot open root device "mtdblock1" or unknown-block(31,1)
>> Please append a correct "root=" boot option; here are the available partitions:
>> 1f00 256 mtdblock0 (driver?)
>> 1f01 11264 mtdblock1 (driver?)
>> 1f02 3072 mtdblock2 (driver?)
>> 1f03 17920 mtdblock3 (driver?)
>> 1f04 128 mtdblock4 (driver?)
>> 1f05 128 mtdblock5 (driver?)
>> Kernel panic - not syncing: VFS: Unable to mount root fs on unknown-block(31,1)
>> Backtrace:
>> [<c003a3dc>] (dump_backtrace+0x0/0x12c) from [<c003a520>] (dump_stack+0x18/0x1c)
>> r7:c7c11000 r6:fffffffb r5:c7c11000 r4:00000000
>> [<c003a508>] (dump_stack+0x0/0x1c) from [<c0046628>] (panic+0x3c/0xc4)
>> [<c00465ec>] (panic+0x0/0xc4) from [<c0008d58>] (mount_block_root+0x110/0x2e8)
>> r3:00000000 r2:20000013 r1:c7c27f58 r0:c0276b44
>> [<c0008c48>] (mount_block_root+0x0/0x2e8) from [<c0008f84>]
>> (mount_root+0x54/0x6c)
>> [<c0008f30>] (mount_root+0x0/0x6c) from [<c0009094>]
>> (prepare_namespace+0xf8/0x194)
>> r5:c001a56c r4:c001a570
>> [<c0008f9c>] (prepare_namespace+0x0/0x194) from [<c0008aa4>]
>> (kernel_init+0x114/0x15c)
>> r6:c0019b0c r5:c0019d5c r4:c02c4e18
>> [<c0008990>] (kernel_init+0x0/0x15c) from [<c0048e98>] (do_exit+0x0/0x628)
>> r6:00000000 r5:00000000 r4:00000000
>>
>>
>>
>> If I disable logfs, my root /dev/mtdblock1 is mounted correclty.
>
> So this issue looks unrelated, but a bug none the less (if just enabling
> logfs breaks the mount).
>
> --
> Jens Axboe
>
>
--
unsubscribe notice To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to
majordomo@vger.kernel.org
More majordomo info at
http://vger.kernel.org/majordomo-info.html
Please read the FAQ at
http://www.tux.org/lkml/ Messages in current thread:
Re: [PATCH 2/2] [MTD] Call bdi_init() and bdi_register() , Paolo Minazzi , (Tue Apr 27, 2:26 am)
