Hello.

On 11-12-2010 22:43, Igor Plyatov wrote:

quoted text
>>> I do not test this driver, but I think it have the same problem, because
>>> it have the same algorithm for timings calculation.

quoted text
>>      I quickly looked thru both drivers and the algorithm seemed different. :-)

quoted text
> I don't think so...

    In fact, the algorithm is slightly different.

quoted text
>>> If you will see "cycle" value greater then 63, then problem exists.

quoted text
>>      I thought the problem was with active pulse width, not total cycle time...

quoted text
> The problem was - the same "cycle" variable used to set up NRD_CYCLE
> (max value = 127) and NCS_RD_PULSE (max value = 63).
> Where NRD_CYCLE, NCS_RD_PULSE names from datasheet for AT91SAM9.
> If NCS_RD_PULSE > 63, then overflow occur and pulse is much longer then
> required.

    Ah, NCS_RD_PULSE is different from active pulse time which is in the 
variable 'nrd_pulse'.

quoted text
> For the 132 MHz, driver use NCS_RD_PULSE = 80 at device detection moment
> on my board.
> Calculated cycle in at91_ide is the same as for pata_at91 driver.

    Yes, but NCS_RD_PULSE is different in these drivers, it's cycle_time in 
at91_ide.c and (cycle time - 2) in the pata_at91.c... Then there should indeed 
be an error in at91_ide.c as well.

quoted text
>>> Generally, I does not see any reasons to use at91_ide, because ATA
>>> drivers subsystem going to replace IDE drivers.

quoted text
>>      There may be reasons -- like larger thruput in PIO mode (you have to check
>> this though -- but generally libata seems very slow in PIO). Anyway, it
>> doesn't mean that the bugs in IDE drivers should be ignored, and the
>> replacemtn will not happen anytime soon (not all IDE drivers are ported to
>> libata yet).

quoted text
> I will send next patch where this driver corrected and tested.

    Thanks. :-)

quoted text
> Best regards!
> --
> Igor Plyatov

WBR, Sergei
--
unsubscribe notice
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@vger.kernel.org
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/