Yinghai Lu wrote:
Unfortunately its a bit difficult because printk() output isn't
appearing at early boot (not sure why). I'll try to extract something
useful tomorrow.
Perhaps this is helpful:
This the e820 map of a regular boot:
BIOS-provided physical RAM map:
Xen: 0000000000000000 - 000000000009f000 (usable)
Xen: 0000000000100000 - 0000000010000000 (usable)
debug: ignoring loglevel setting.
limit_regions start: 0000000000000000 - 000000000009f000 (usable)
limit_regions start: 0000000000100000 - 0000000010000000 (usable)
limit_regions endfunc: 0000000000000000 - 000000000009f000 (usable)
limit_regions endfunc: 0000000000100000 - 0000000010000000 (usable)
user-defined physical RAM map:
user: 0000000000000000 - 000000000009f000 (usable)
user: 0000000000100000 - 0000000010000000 (usable)
0MB HIGHMEM available.
256MB LOWMEM available.
[...]
Entering add_active_range(0, 0, 65536) 0 entries of 256 used
Zone PFN ranges:
DMA 0 -> 4096
Normal 4096 -> 65536
HighMem 65536 -> 65536
Movable zone start PFN for each node
early_node_map[1] active PFN ranges
0: 0 -> 65536
On node 0 totalpages: 65536
DMA zone: 56 pages used for memmap
DMA zone: 0 pages reserved
DMA zone: 4040 pages, LIFO batch:0
Normal zone: 840 pages used for memmap
Normal zone: 60600 pages, LIFO batch:15
HighMem zone: 0 pages used for memmap
Movable zone: 0 pages used for memmap
.config attached.
J