Re: Bad value with w83627thf

Previous message: [thread] [date] [author]
Next message: [thread] [date] [author]
From: Jean Delvare
Date: Friday, May 16, 2008 - 6:27 am

Hi Oliver,

You are writing to the wrong mailing list (i2c instead of lm-sensors)
so I am redirecting.

On Fri, 16 May 2008 14:59:21 +0200, Oliver Pinter wrote:

There is nothing wrong here. +3.26V sounds possible and correct for the
battery voltage. If you are worried about the min and max values: it is
up to you to edit your sensors3.conf file to set them properly if the
BIOS of your motherboard did not (apply the changes with "sensors -s").
The alarm will go away when you do.


Completely irrelevant here, the Winbond W83627THF is an LPC chip, it
doesn't have an I2C/SMBus interface, so the SMBus controller doesn't
matter at all.

-- 
Jean Delvare
--
Previous message: [thread] [date] [author]
Next message: [thread] [date] [author]

Messages in current thread:
Bad value with w83627thf, Oliver Pinter, (Fri May 16, 5:59 am)
Re: Bad value with w83627thf, Jean Delvare, (Fri May 16, 6:27 am)
Re: Bad value with w83627thf, Oliver Pinter, (Fri May 16, 6:45 am)
Re: Bad value with w83627thf, Jean Delvare, (Fri May 16, 7:26 am)
Re: Bad value with w83627thf, Oliver Pinter, (Fri May 16, 7:34 am)