Hi everyone,

I use a INTEL D201GLY2A mainboard, and after serveral trys PCI devices 
were only useable (not visable) with the boot-parameter acpi=noirq (or 
noacpi). I tryed several kernel-versions (stated with 2.6.22), and no 
sucess without his parameter.
Without acpi=noirq all pci devices are deteced well, but if you want to 
use them, there is no response.

So, now some (as I thnik) relevant informations:
lspci
00:00.0 Host bridge: Silicon Integrated Systems [SiS] 662 Host (rev 01)
00:01.0 PCI bridge: Silicon Integrated Systems [SiS] SiS AGP Port
00:02.0 ISA bridge: Silicon Integrated Systems [SiS] SiS964 [MuTIOL
00:02.5 IDE interface: Silicon Integrated Systems [SiS] 5513 [IDE] (rev
00:02.7 Multimedia audio controller: Silicon Integrated Systems [SiS]
00:03.0 USB Controller: Silicon Integrated Systems [SiS] USB 1.1
00:03.1 USB Controller: Silicon Integrated Systems [SiS] USB 1.1
00:03.2 USB Controller: Silicon Integrated Systems [SiS] USB 1.1
00:03.3 USB Controller: Silicon Integrated Systems [SiS] USB 2.0
00:04.0 Ethernet controller: Silicon Integrated Systems [SiS] SiS900 PCI
00:05.0 IDE interface: Silicon Integrated Systems [SiS] SATA (rev 01)
00:06.0 Ethernet controller: Atheros Communications Inc. AR5212/AR5213
00:1f.0 PCI bridge: Silicon Integrated Systems [SiS] PCI-to-PCI bridge
01:00.0 VGA compatible controller: Silicon Integrated Systems [SiS]


.config (I did not attach all information about drivers, because I don´t 
think that this is ...
[ message continues ]

Probably your best approach will be to raise a report against acpi at
bugzilla.kernel.org, please.  These things do get fixed, but it takes
some time.

Thanks.
--

[ message continues ]