"mount: could not find filesystem" - aacraid? (was: Re: 2.6.26-git0: IDE oops during boot)

!MAILaRCHIVE_VOTE_RePLACE
Previous message: [thread] [date] [author]
Next message: [thread] [date] [author]
To: Kamalesh Babulal <kamalesh@...>
Cc: Nish Aravamudan <nish.aravamudan@...>, Pavel Machek <pavel@...>, kernel list <linux-kernel@...>, <linux-ide@...>, <ananth@...>, Andi Kleen <andi@...>, <linux-scsi@...>, <aacraid@...>
Date: Thursday, February 14, 2008 - 8:01 am

Hi,

On Thursday 14 February 2008, Kamalesh Babulal wrote:

Hmm, it is not (from dmesg):

Uniform Multi-Platform E-IDE driver Revision: 7.00alpha2
ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx
Probing IDE interface ide0...
hda: HL-DT-STCD-RW/DVD DRIVE GCC-4244N, ATAPI CD/DVD-ROM drive
Probing IDE interface ide1...
ide0 at 0x1f0-0x1f7,0x3f6 on irq 14
hda: ATAPI 24X DVD-ROM CD-R/RW drive, 2048kB Cache
Uniform CD-ROM driver Revision: 3.20

[...]

Adaptec aacraid driver 1.1-5[2449]-ms
ACPI: PCI Interrupt 0000:01:02.0[A] -> GSI 25 (level, low) -> IRQ 25
AAC0: kernel 5.2-0[11835] Jan  9 2007
AAC0: monitor 5.2-0[11835]
AAC0: bios 5.2-0[11835]
AAC0: serial 1625D1
AAC0: 64bit support enabled.
AAC0: 64 Bit DAC enabled
scsi0 : ServeRAID
scsi 0:0:0:0: Direct-Access     IBM      x366             V1.0 PQ: 0 ANSI: 2
scsi 0:1:0:0: Direct-Access     IBM-ESXS ST973401SS       B519 PQ: 0 ANSI: 5
scsi 0:1:1:0: Direct-Access     IBM-ESXS ST973401SS       B519 PQ: 0 ANSI: 5
scsi 0:1:2:0: Direct-Access     IBM-ESXS ST973401SS       B519 PQ: 0 ANSI: 5
scsi 0:3:0:0: Enclosure         IBM      SAS SES-2 DEVICE 0.09 PQ: 0 ANSI: 5
sd 0:0:0:0: [sda] 429459456 512-byte hardware sectors (219883 MB)
sd 0:0:0:0: [sda] Write Protect is off
sd 0:0:0:0: [sda] Mode Sense: 06 00 10 00
sd 0:0:0:0: [sda] Write cache: enabled, read cache: enabled, supports DPO and FUA
sd 0:0:0:0: [sda] 429459456 512-byte hardware sectors (219883 MB)
sd 0:0:0:0: [sda] Write Protect is off
sd 0:0:0:0: [sda] Mode Sense: 06 00 10 00
sd 0:0:0:0: [sda] Write cache: enabled, read cache: enabled, supports DPO and FUA
 sda: sda1 sda2 sda3 sda4 < sda5 sda6 >
sd 0:0:0:0: [sda] Attached SCSI removable disk
sd 0:0:0:0: Attached scsi generic sg0 type 0
scsi 0:1:0:0: Attached scsi generic sg1 type 0
scsi 0:1:1:0: Attached scsi generic sg2 type 0
scsi 0:1:2:0: Attached scsi generic sg3 type 0
scsi 0:3:0:0: Attached scsi generic sg4 type 13

[...]

kjournald starting.  Commit interval 5 seconds
EXT3-fs: mounted filesystem with ordered data mode.

[...]

EXT3 FS on sda1, internal journal
kjournald starting.  Commit interval 5 seconds
EXT3 FS on sda2, internal journal
EXT3-fs: mounted filesystem with ordered data mode.

I worry that another git-bisect session will be needed unless SCSI
developers are already aware of the problem source.

Thanks,
Bart
--
Previous message: [thread] [date] [author]
Next message: [thread] [date] [author]

Messages in current thread:
Re: 2.6.26-git0: IDE oops during boot, Pavel Machek, (Wed Feb 6, 7:08 am)
Re: 2.6.26-git0: IDE oops during boot, Bartlomiej Zolnierkiewicz..., (Wed Feb 6, 4:05 pm)
Re: 2.6.26-git0: IDE oops during boot, Kamalesh Babulal, (Thu Feb 7, 5:35 am)
Re: 2.6.26-git0: IDE oops during boot, Bartlomiej Zolnierkiewicz..., (Thu Feb 7, 10:01 am)
Re: 2.6.26-git0: IDE oops during boot, Nish Aravamudan, (Sun Feb 10, 5:32 pm)
Re: 2.6.26-git0: IDE oops during boot, Kamalesh Babulal, (Mon Feb 11, 3:54 am)
Re: 2.6.26-git0: IDE oops during boot, Bartlomiej Zolnierkiewicz..., (Mon Feb 11, 3:35 pm)
Re: 2.6.26-git0: IDE oops during boot, Kamalesh Babulal, (Tue Feb 12, 5:04 am)
Re: 2.6.26-git0: IDE oops during boot, Bartlomiej Zolnierkiewicz..., (Wed Feb 13, 7:00 pm)
Re: 2.6.26-git0: IDE oops during boot, Kamalesh Babulal, (Thu Feb 14, 5:46 am)
"mount: could not find filesystem" - aacraid? (was: Re: 2.6...., Bartlomiej Zolnierkiewicz..., (Thu Feb 14, 8:01 am)
Re: "mount: could not find filesystem" - aacraid? (was: Re: ..., Bartlomiej Zolnierkiewicz..., (Thu Feb 14, 8:07 am)
Re: 2.6.26-git0: IDE oops during boot, Yinghai Lu, (Thu Feb 14, 6:28 am)
Re: 2.6.26-git0: IDE oops during boot, Kamalesh Babulal, (Fri Feb 15, 7:15 am)
Re: 2.6.26-git0: IDE oops during boot, Yinghai Lu, (Mon Feb 25, 3:05 am)
Re: 2.6.26-git0: IDE oops during boot, Yinghai Lu, (Mon Feb 25, 3:23 am)