On Fri, 14 Nov 2008 20:57:22 +0200, Maxim Levitsky wrote
quoted text
> Bob Copeland wrote:
> > On Wed, Nov 12, 2008 at 07:51:47PM +0200, Maxim Levitsky wrote:
> >>>> Why it doesn't accept new mac?, can this be fixed?
> >> Any update on mac changer status?
> > 
> > As a first stab, can you try this patch?  This sets the address on
> 
> Works almost perfectly,
> 
> when I load the module, then run macchanger, and then ifconfig wlan0 up
> then it works, if I do an ifconfig up once, then ifdowning the interface, it
> doesn't.

Yeah, I had actually written more for that patch originally, but didn't 
post it because it was a bit more invasive.  I think the issue is just that 
start() shouldn't program the mac at all and let add_interface handle that.
I'll post a revised patch in a day or two.

quoted text
> The noise floor calibration issue bites me again and gain.
> When it shows up, usually card continues to work, but at next assotiation
> stops working.

Does this help?
http://marc.info/?l=linux-wireless&m=122570806813839&w=2

quoted text
> Transfer speeds are unusually low:

You can try using the minstrel rate control algorithm, it may help.

-- 
Bob Copeland %% www.bobcopeland.com


--
unsubscribe notice
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@vger.kernel.org
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/