On Tue, 22 Jan 2008 21:40:21 +0100
Manuel Reimer <Manuel.Spam@nurfuerspam.de> wrote:

quoted text
> Jeff Garzik wrote:
> > If your IDE interface is complaining about BadCRC errors, then it's 
> > complaining about hardware problems (bad cable, etc.)
> 
> The cable already has been replaced three times. I even got sure to 
> *not* bend the cable. This all doesn't help.
> 
> May a bad cable really cause corrupted data?

Yes, or dodgy connectors or other problems. The CRC itself is computed by
the hardware each end so a BadCRC error really means the two ends
disagree about the data. 

That is *usually* a cable/electrical noise problem. It can be power and
it can occasionally show up if the software misprograms the timing so the
two ends are a bit out of sync.

Alan
--
unsubscribe notice
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@vger.kernel.org
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/