> Hi,
>
> [Adding linux-ide to CC]
>
> On 25/08/07, Bryan Woods <bryan@arbores.ca> wrote:
>> Hi KML
>>
>> I am installing gentoo 2007.0 (kernel 2.6.19) on a dual AMD Opteron server (total of 4 cores). The hard disk is a Stardom 2611-2S-S1 device: actually two 250GB drives in a RAID0 config managed by the device itself - it should appear to the kernel as one SATA drive. If it matters, the underlying HDs are "Seagate Barracuda 7200 10"s. Here's the device:
>>
>>
http://www.synetic.net/Synetic-Products/Stardoms/SR-2611-SA/Stardom-2611.htm
>>
>> During the install and at different points in the process I get an "HSM violation" and the system becomes unresponsive. It looks like a similar situation to:
>>
>>
http://lkml.org/lkml/2007/6/6/195
>>
>> Will more recent kernels work with this hardware (should I keep it and try the install again) or should I switch hardware to something more compatible (like an Adaptec card)?
>>
>> Thanks!
>> Bryan
>>
>> --
>> console output:
>>
>> tag 0 cmd 0x39 Emask 0x2 stat 0x58 err 0x0 (HSM violation)
>> exception Emask 0x0 SAct 0x0 SErr 0x0 action 0x2 frozen
>>
>> --
>> Output from hdparm -I /dev/sda:
>>
>> /dev/sda:
>>
>> ATA device, with non-removable media
>> Model Number: STARDOM V.36.A0B
>> Serial Number:
>> Firmware Revision: V.36.A0B
>> Standards:
>> Used: ATA/ATAPI-6 T13 1410D revision 0
>>
>> [snip]
>>
>> Commands/features:
>> Enabled Supported:
>> * SMART feature set
>> * Power Management feature set
>> * Advanced Power Management feature set
>> * 48-bit Address feature set
>> * Mandatory FLUSH_CACHE
>> * SATA-I signaling speed (1.5 Gb/s)
>> * SATA-II signaling speed (3.0 Gb/s)
>>
>> --
>> Parts of dmesg:
>> libata version 2.00 loaded
>> sata_nv 0000:00:05.0: version 2.0
>> ata1: SATA max UDMA/133 cmd 0xD480 ctl 0xD402 bmdma 0xCC00 irq 21
>> ata2: SATA max UDMA/133 cmd 0xD080 ctl 0xD002 bmdma 0xCC08 irq 21
>> scsi0 : sata_nv
>> ata1: SATA link up 1.5 Gbps (SStatus 113 SControl 300)
>> ata1.00: ATA-6, max UDMA/133,976794112 sectors: LBA48
>> ata1.00: ata1: dev 0 multi count 1
>> ata1.00: applying bridge limits
>> ata1.00: configured for UDMA/100
