Hello,
We have a system where the rootfs is a partition on a USB device,
and I've noticed upon a few rare cases where the USB controller
loses the connection to the USB device after some uptime (days,
weeks...), and the USB device reappears a very short time later.
It doesn't really matter why, I guess that USB controllers and
storage devices aren't always of the best quality - let's assume
that. The issue is that Linux currently makes it problematic
to recover the rootfs for several reasons.
If /dev/sda1 is mounted as root and the SCSI device goes into
offline mode, it is quite impossible to get out of this situation.
At first, I had to disable the usermode helper that sends events
to udev since it blocks on the dysfunction /dev/sda1. Afterwards,
I noticed that the reappearing device is being assigned with
/dev/sdb along with a new SCSI host. I guess the the VFS and
block layer still keep a reference to the old scsi_disk and as
a result sd doesn't free it.
So, I gave some thoughts about this, I and came up with two
main solutions:
1) Improve the USB storage error handling - bind the already
existing SCSI host to the USB port that has the device, e.g.,
if host2 got created for usb 5-3 then keep it that way for the
sake of EH. /dev/sda1 should come to life when the USB device
recovers, unless a few seconds have passed or some attributes
(such as manufactor id or serial) have changed.
2) Block layer hack - Write a special layering block device
driver that acts as a proxy to the currently functioning
/dev/sd* which gets auto-detected by this block layer driver.
md multipath for the 'poor', you might say..
I chose '2' for the time being. It was much easier than hacking
around the USB subsystem... Yes, I know rootfs on USB is an
uncommon use-case at the moment but I do like to know if there
are some improvements planned in this area.
--
Dan Aloni
XIV LTD, http://www.xivstorage.com
da-x (at) monatomic.org, dan (at) xiv.co.il
-
