Hi,

quoted text
> According to the HyperTransport spec, 'En' indicate if the MSI Mapping is
> active. So it should be set when enable the MSI.

Great! This is what I needed to get MSI going on my MCP51 board. I added so=
me=20
ids, but I think there were not necessary, as I only got

PCI: 0000:00:00.0: enabled HT MSI mapping
PCI: 0000:00:10.1: enabled HT MSI mapping

were those devices are:
00:00.0 RAM memory: nVidia Corporation C51 Host Bridge (rev a2)
        Subsystem: ASUSTeK Computer Inc. Unknown device 81c0
        Flags: bus master, 66MHz, fast devsel, latency 0
        Capabilities: [44] HyperTransport: Slave or Primary Interface
        Capabilities: [e0] HyperTransport: MSI Mapping Enable+ Fixed-
00: de 10 f0 02 06 00 b0 00 a2 00 00 05 00 00 80 00
10: 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00
20: 00 00 00 00 00 00 00 00 00 00 00 00 43 10 c0 81
30: 00 00 00 00 44 00 00 00 00 00 00 00 ff 00 00 00

According to your patch, you named this device
+#define PCI_DEVICE_ID_NVIDIA_NFORCE_C51_MEMC0   0x02F0
So is the lspci database not correct or your naming? lspci lists some=20
memcontrollers for me, but they don't seem to have MSI specific items.


00:10.1 Audio device: nVidia Corporation MCP51 High Definition Audio (rev a=
2)
        Subsystem: ASUSTeK Computer Inc. Unknown device 81cb
        Flags: bus master, 66MHz, fast devsel, latency 0, IRQ 319
        Memory at fe024000 (32-bit, non-prefetchable) [size=3D16K]
        Capabilities: [44] Power Management version 2
        Capabilities: [50] Message Signalled Interrupts: Mask+ 64bit+=20
Queue=3D0/0 Enable+
        Capabilities: [6c] HyperTransport: MSI Mapping Enable+ Fixed+
00: de 10 6c 02 06 04 b0 00 a2 00 03 04 00 00 80 00
10: 00 40 02 fe 00 00 00 00 00 00 00 00 00 00 00 00
20: 00 00 00 00 00 00 00 00 00 00 00 00 43 10 cb 81
30: 00 00 00 00 44 00 00 00 00 00 00 00 05 02 02 05

Yay:
cat /proc/interrupts
319:         26       9357   PCI-MSI-edge      HDA Intel


So, now sata_nv and nvidia binary graphics driver could activate MSI, as=20
well. :-)

One thing I noticed in the patch:
+		if (((bridge_dev =3D pci_find_slot(0, 0)) !=3D NULL) &&

You rather want to use pci_get_bus_and_slot instead, as pci_find_slot is=20
deprecated.

Thanks!
=2D-=20
(=A1=E3=3D                 =3D=A1=E3)
//\ Prakash Punnoor /\\
V_/                 \_V