On 295, 10 22, 2007 at 12:18:08PM -0400, Lennart Sorensen wrote:
quoted text
> On Mon, Oct 22, 2007 at 07:33:23PM +0400, Andrey Panin wrote:
> > So the card probably generates screaming interrupt... that's bad.
> > I found some docs for IT887x chips, according to these docs  IT887x
> > have simple interrupt controller inside. Further investigation is neede=
d.
quoted text
> >=20
> > Can you post output of lspci -xxx ?
>=20
> Is it possible they put a chip on to generate a PCI interrupt on perhaps
> PCIB on the slot from the serial chips directly, so that they didn't
> have to turn interrupts from the serial chips into a signal that forces
> the parallel port to generate an interrupt?  After all that would reduce
> latency, and if you use PCIA for the parallel port, PCIB for the first
> serial chip and PCIC for the second, you might get a much more efficient
> design, although the driver would have to register all those IRQs.

I dont think so. IT887x has builtin interrupt controller which multiplexes=
=20
16 external IRQ pins with IRQs from builtin devices (parallel port, UARTs
and GPIO) into single INTA# line. IT887x also contains 8-bit ISA-like bus
and 16 chip select lines and it's all you need to glue UARTs to PCI bus.

I suspect that it's interrupt controller problem, probably edge/level
triggered settings.

quoted text
> What IRQ is each PCI device in that system using right now?  perhaps we
> could figure out what irq 17 would be on that PCI slot.

--=20
Andrey Panin		| Linux and UNIX system administrator
pazke@donpac.ru		| PGP key: wwwkeys.pgp.net