Hi, I just pulled out my Marvell 7042 SATA controller here to give it a spin and noticed that it no longer worked (i.e. init segvs when loading from it), etc. 2.6.22 is fine. Bisecting (just the file drivers/ata/sata_mv.c) resulted in bdd4dddee325a7dce3e84cf48201a06aa8508aa4 popping out as the culprit (file version 4537deb5e90b717a725b3d74b58b4bb1d28443d0 is fine). Just for sanity checking: Has anyone else used 7042/6042 with the current mainline driver? Hardware config in my case: Highpoint 2310 controller PPC (big endian) WD Raptor disk Works fine with the other controller I've been using (SIL24), and works fine if I revert the driver. It also works fine if I disable the IOMMU. This would point towards either a stale dma mapping, or a missing setup of one. Not being much at home in the SATA drivers I could keep digging but I figured I'd bring it up first in case it rings a bell for someone. -Olof -
| Trent Piepho | [PATCH] [POWERPC] Improve (in|out)_beXX() asm code |
| Andi Kleen | [PATCH] [4/50] x86: add cpu codenames for Kconfig.cpu |
| Andi Kleen | [PATCH] [0/45] x86 2.6.24 patches review I |
| Stoyan Gaydarov | From 2.4 to 2.6 to 2.7? |
git: | |
| Jarek Poplawski | Re: HTB accuracy for high speed |
| David Miller | Re: [GIT]: Networking |
| Gerrit Renker | [PATCH 13/37] dccp: Deprecate Ack Ratio sysctl |
| Jarek Poplawski | Re: [PATCH] pkt_sched: Destroy gen estimators under rtnl_lock(). |
