On Monday 01 January 2007 12:55 pm, Pavel Machek wrote:

quoted text
> > Think of it as "cookies represented by integers" if you like.
> 
> typedef int gpio_t would hurt, and would serve as a useful
> documentation hint.

Yes, I agree that such needless obfuscation hurts.  ;)

Plus, such a typedef would disagree with Documentation/CodingStyle
which says "... the rule should basically be to NEVER EVER use a
typedef" (with some exceptions not matched here).


quoted text
> > Should it instead say that's an (obviously unchecked) error?
> 
> Saying it is an error would be okay by me. (Or "Behaviour of these calls for
> GPIOs that can't be safely accessed without sleeping is undefined.").

See the appended doc patch ... better?

- Dave


=================	CUT HERE
Index: at91/Documentation/gpio.txt
===================================================================
--- at91.orig/Documentation/gpio.txt	2006-12-29 00:00:28.000000000 -0800
+++ at91/Documentation/gpio.txt	2006-12-29 15:47:18.000000000 -0800
@@ -78,7 +78,8 @@ Identifying GPIOs
 -----------------
 GPIOs are identified by unsigned integers in the range 0..MAX_INT.  That
 reserves "negative" numbers for other purposes like marking signals as
-"not available on this board", or indicating faults.
+"not available on this board", or indicating faults.  Code that doesn't
+touch the underlying hardware treats these integers as opaque cookies.
 
 Platforms define how they use those integers, and usually #define symbols
 for the GPIO lines so that board-specific setup code directly corresponds
@@ -139,8 +140,8 @@ issues including wire-OR and output late
 The get/set calls have no error returns because "invalid GPIO" should have
 been reported earlier in gpio_set_direction().  However, note that not all
 platforms can read the value of output pins; those that can't should always
-return zero.  Also, these calls will be ignored for GPIOs that can't safely
-be accessed wihtout sleeping (see below).
+return zero.  Also, using these calls for GPIOs that can't safely be accessed
+without sleeping (see below) is an error.
 
 Platform-specific implementations are encouraged to optimise the two
 calls to access the GPIO value in cases where the GPIO number (and for
@@ -239,7 +240,8 @@ options are part of the IRQ interface, e
 system wakeup capabilities.
 
 Non-error values returned from irq_to_gpio() would most commonly be used
-with gpio_get_value().
+with gpio_get_value(), for example to initialize or update driver state
+when the IRQ is edge-triggered.
 
 
 
@@ -262,7 +264,8 @@ like the aforementioned options for inpu
 Hardware may support reading or writing GPIOs in gangs, but that's usually
 configuration dependednt:  for GPIOs sharing the same bank.  (GPIOs are
 commonly grouped in banks of 16 or 32, with a given SOC having several such
-banks.)  Code relying on such mechanisms will necessarily be nonportable.
+banks.)  Some systems can trigger IRQs from output GPIOs.  Code relying on
+such mechanisms will necessarily be nonportable.
 
 Dynamic definition of GPIOs is not currently supported; for example, as
 a side effect of configuring an add-on board with some GPIO expanders.
-
unsubscribe notice
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@vger.kernel.org
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/