Dear Linux Gurus,
                 I'm having problems with the groff binaries from tsx.  Having 
installed all the bits in /usr/local/ then moved them /usr (OK, so I got it 
wrong to start off with :-)  I get the following error message when I try & read
any of the man pages.

using groff -man -T ascii /usr/man/man1/gtroff.1
I get the following on /dev/tty (not stderr !) :-
        d9f2 fxxx not implemented
& this on stderr :-
        groff: groff: Signal 4

I get some of the man page on screen, but not all - always stops at the same 
place.

Any ideas ?  I'm supprised I'm getting a message to /dev/tty (ie the message 
will go to the current virt. console - not the one issuing the command)

I've undoubtedly done something wrong/stupid but I'm supprised the errors 
haven't all gone to stderr.

Chears,

Tony
                                                    _
Tony Kew,   Oxford University Computing Services,  (_)xford,  England,  U.K.
====================================================|=========================
Janet:- tony@uk.ac.oxford.vax                     --+--    Disclaimer :-
Internet:- tony%vax.oxford.ac.uk@nsfnet-relay.ac.uk | Who is the more foolish?
Earn/Bitnet:- tony%vax.oxford.ac.uk@ukacrl          |    The fool, or the
Phone:- +44 (0)865 273268   Fax:- +44 (0)865 273275 |  man who follows him?
==================================================\=|=/=======================
                                                   \|/