I'm having problems with elm ans smail...I compiled them and installed them as
the readmes instructed, and they seemed to compile without a hitch (well, they
did have a _few_ warnings :-).
Anyhow, now, when I try to run them, I get the message
        /lib/libc.2.2.2
and a command prompt. (Yes, I used a valid username to test it.)
Smail is nicer--it only fails to run; Elm drops me back to the prompt and screws
up my terminal to the point that I have to log out and back on (setterm -init 
and setterm -reset have no effect...)
I installed the GCC libs as the instructions said...and before you ask, here's
the setup:
        0.97pl1.5 (patch1 + the 1 line patch)
        GCC 2.2.2 (_NOT_ 2.2.2d, but the 2.2.2 distrib from banjo)
        AMD386DX-33 no 387
        8M RAM, 5M swap
        IDE drives
Can someone out there help me? Please?

                                        James

James P. Callison       Microcomputer Coordinator        OU Law Library 
Callison@aardvark.ucs.uoknor.edu   /\        Callison@uokmax.ecn.uoknor
        constellation!biglaw!callison@mailhost.ecn.uoknor.edu
DISCLAIMER: I'm not an engineer, but I play one at work...
        Here's to all the soldiers who have ever died in vain,
        The insane locked up in themselves, the homeless down on Main
        To those who stand on empty shores, and spit against the wind
        And those who wait forever for ships that don't come in
                --Joe Diffee, "Ships That Don't Come In"