Hello linuxers!  I've got the following set-up and am having problems
getting linux to recognize my scsi drives:
        magitronic 386dx/40 16 meg ram
        generic ide controller and 43 meg seagate ide drive
        WD7000 scsi card and two 85 meg seagate scsi drives attached
        Tseng Lab ET4000 video card & svga monitor
        generic serial card

I've installed linux on partition two of my 43 meg ide drive.  Things
seem to work great so far.  The problem is this:  linux finds my wd7000
scsi card when I boot from the boot disk v9.8.1  It also says read 
capacity lun_0 is 85 megs and read capacity lun_1 is 85 megs, however
it never actually finds the drives, it reports back 0 drives, 0 tape-drives
found.  Has anyone out there had any experience with getting the WD7000
to work with linux?  If so could you let me know via e-mail since I dont
read this group.

btw: the wd7000 works great under dos so I dont know what that means...

==================save energy: use a small sig!  mopar@uxa.cso.uiuc.edu=======