On Wed, Dec 23, 2009 at 08:18:48AM +0000, Aditya Sarawgi wrote:
quoted text
> On Tue, Dec 22, 2009 at 07:53:31PM -0800, Weongyo Jeong wrote:
> > Hello,
> > 
> > Now bwn(4) is available at the public and waiting test and review.  The
> > status of this driver is *alpha* so could make panics, warnings and
> > errors.  Please let me know if you encounter problems.
> > 
> > The following NICs all I have are only tested on the little endian 64bit
> > machine and big endian 32bit machine.
> > 
> >   - Broadcom BCM4306 802.11b/g Wireless
> >   - Broadcom BCM4318 802.11b/g Wireless
> > 
> > I tested basic RX, TX and WPA association as STA mode and checked it
> > worked.
> > 
> > As you might know there are still a lot of TODO in the driver so you
> > could see some verbose messages during testing so please ignore or let
> > me know it makes problems.
> > 
> > == How to build and load ==
> > 
> >   # cd /usr/src/sys
> >   # fetch http://people.freebsd.org/~weongyo/bwn_20091222.tar.gz
> >   # tar xzf bwn_20091222.tar.gz
> >   # cd modules/ssb
> >   # make && make install
> >   # cd ../..
> >   # cd modules/bwn
> >   # make && make install
> >   # cd somewhere
> >   # fetch http://people.freebsd.org/~weongyo/bwn_ports_20091222.tar.gz
> >   # tar xzf bwn_ports_20091222.tar.gz
> >   # cd sysutils/b43-fwcutter
> >   # make install clean
> >   # cd ../..
> >   # cd net/bwn-firmware-kmod
> >   # make install clean
> >   #
> >   # kldload ssb
> >   # kldload bwn_v4_ucode
> >   # kldload if_bwn
> > 
> > regards,
> > Weongyo Jeong
> > 
> 
> Hi,
> 
> The driver doesn't work with BCM4315, here's what dmesg shows 
> 
> ssb0: <Broadcom BCM4315 802.11b/g Wireless> mem 0xf4000000-0xf4003fff 
> irq 19 at device 0.0 on pci6
> bwn0 on ssb0
> bwn0: unsupported PHY type (5)
> device_attach: bwn0 attach returned 6

FYI bwn(4) driver is committed into FreeBSD tree.  I think the driver 
supports your LP PHY device.  After cvsup please try to rebuild siba_bwn
and bwn modules.

Could you please test with it?  Please let me know and send me your 
full dmesg when you encounters the following problems:

  - if the driver doesn't work or is unstable.
  - if it prints debugging or verbose messages.

regards,
Weongyo Jeong

_______________________________________________
freebsd-current@freebsd.org mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-current
To unsubscribe, send any mail to "freebsd-current-unsubscribe@freebsd.org"